Bi-Directional IDE to SATA or SATA to IDE Adapter - Retail Hanging Package

Connect an IDE hard drive to your motherboard's Serial ATA controller or vice versa with this Bi-Directional IDE to SATA Converter or SATA to IDE adapter!

It's easy to install and there are no drivers needed! There is a switch for either SATA to IDE or IDE to SATA. Key features include Jmicro JM20330 Chipset, 150 MB/s transfer rate, automatic SATA 3.0/1.5 Gbps speed negotiation, and support for Support 3.5-inch IDE hard drives and 5.25-inch optical drives.

• Bi-Directional IDE to SATA or SATA to IDE Adapter
  
  
  
• General Features:
  
• Jmicro JM20330 Chipset
  
• Bi-Directional adapter
  
• Plug and Play and Hot-Swapping capability
  
• 150 MB/s transfer rate
  
• Automatic SATA 3.0/1.5 Gbps speed negotiation
  
• Serial ATA 1.0 specification compliant
  
• Support Serial ATA hot-plug
  
• Support ATA Host Bridge
  
• Support ATA PIO and UDMA modes 0 to 4
  
• ATA / ATAPI Ultra DMA of transfer rate 16.7, 25, 33, 48, 66, 100, 133, and 150MB/s
  
• ATA / ATAPI LBA48 addressing mode associated with 2-byte sector count
  
• Support 3.5-inch IDE hard drives and 5.25-inch optical drives
  
• Ultra low power consumption
  
• Provide specified OOB signal detection and transmission
  
• Support Spread Spectrum Clocking to reduce EMI
  
• Support Partial/Slumber power management
  
• Provide adjustable TX signal amplitude and pre-emphasis level
  
• Master/Slave mode support
  
• LED power indicator
  
  
  
• Regulatory Approvals:
  
• CE
  
• FCC
  
• C-Tick

• Bi-Directional IDE to SATA or SATA to IDE Adapter
  
• SATA cable
  
• 1 to 3 Power Adapter cable
  
• User Manual